Gas Fitter Terms and Conditions SA: Contracts for Gas Fitters and Gas Fitting Work
Gas fitter terms and conditions in South Australia
Gas fitting carries a liability that outlasts the job. The Technical Regulator can direct the person who did the work to fix an unsafe or non-compliant installation for two years afterwards, and the certificate given at the end of the job is the record everyone relies on. Talon Legal drafts gas fitter terms and conditions, appliance installation terms and gas subcontracts for South Australian gas fitters and gas fitting businesses. Book a same-day free 30-minute consultation or call (08) 7094 2021.
Gas fitter terms and conditions SA key facts
| Issue | Position for gas fitters in South Australia |
|---|---|
| Governing law | Plumbers, Gas Fitters and Electricians Act 1995 (SA) and Regulations 2025; Gas Act 1997 (SA); Australian Consumer Law. Current to 21 November 2026. |
| What gas fitting is | Installing, altering, repairing, maintaining or disconnecting pipes or equipment that convey or use gas downstream of a reticulated gas meter, or of a gas cylinder or tank (PGE Act section 3). |
| Licence | Gas fitting has its own contractor licence, which can be restricted in any way (section 7), and each gas fitter must be registered (section 13). |
| Exempt work | Connecting or disconnecting a gas cylinder and portable equipment (PGE Regulations regulation 4(5)(b)). |
| Compliance | The licensed contractor engaged is responsible for the work, examinations and tests meeting the regulations (Gas Act section 56(1), (3)(a)), and the regulations on notification and certificates of compliance must be complied with (section 56(2)). |
| Rectification | The Technical Regulator can direct rectification of an unsafe or non-compliant installation, including by the person who did the work within two years before the direction (section 57). |
| First step | Same-day free 30-minute consultation. Call (08) 7094 2021. |
Need gas fitter terms and conditions? What this guide covers
This guide covers what is particular to gas fitter terms and conditions in South Australia, current to 21 November 2026: the gas fitting licence and its limits, supplying and installing appliances, testing and certificates of compliance, rectification directions, and getting paid. The law all plumbing, gas and electrical trades share is in the plumbing and electrical contracts SA guide.
We act for gas fitters, gas appliance installers and plumbing businesses that hold gas fitting authority.
Free Consultation. Send us your quote form, your appliance installation terms or a direction from the Technical Regulator. Book a same-day free 30-minute consultation or call (08) 7094 2021.
On this page
- The gas fitting licence and its limits
- Supplying and installing gas appliances
- Testing, notification and certificates
- Rectification directions within two years
- Getting paid for gas fitting work
- What the gas fitter pack holds
- How similar matters tend to play out
- Gas fitting case law
- How we build gas fitter terms and conditions
- Frequently asked questions
- Related trade contract guides
The gas fitting licence and its limits
| Question | Position |
|---|---|
| Is gas fitting separate from plumbing? | Yes. The PGE Act licenses plumbing, gas fitting and electrical contracting as separate classes, and a gas fitting licence can be restricted in any way (section 7). |
| Who does the work? | A registered gas fitting worker authorised for it, or the contractor commits an offence (sections 12, 13). Registration can be restricted too (section 14). |
| What is exempt? | Connecting or disconnecting a gas cylinder and portable equipment (regulation 4(5)(b)). |
| Does a gas fitter need a builders licence? | Not for building work the gas fitting licence authorises (Building Work Contractors Regulations regulation 5(1)). |
| Can a builder contract for gas work? | A builder is exempt from the gas fitting contractor licence on condition that the work is performed in the ordinary course of the business by a person licensed or registered for it (PGE Regulations regulation 4(1)). |
| Advertising | A licensed contractor's advertisement must state the licence number (section 33A). |
“Perform” includes causing, organising or arranging the work (section 3), so a business that sells gas appliances installed, and books gas fitters to install them, is performing gas fitting. Green Engineering, below, concerned electrical work under the same definition. An unlicensed contractor is not entitled to any fee or other consideration for its work unless a court is satisfied the failure resulted from inadvertence only (section 6(2)).
Supplying and installing gas appliances
A gas fitter who supplies the appliance as well as fitting it takes on obligations for both.
- The appliance. Goods supplied to a consumer carry a guarantee of acceptable quality (Australian Consumer Law section 54), and the supplier is the gas fitter where the gas fitter supplied it.
- The work. Services supplied to a consumer must be rendered with due care and skill (section 60).
- The manufacturer’s warranty. Its benefits sit beside the guarantees. The terms should say who registers it, who deals with the manufacturer, and what the gas fitter charges for attending a warranty fault.
- Client-supplied appliances. Where the client buys the appliance, the terms should say the gas fitter installs it as supplied and is responsible for the installation, not the appliance.
- Commercial kitchens and plant. For goods or services not of a kind ordinarily acquired for personal, domestic or household use, liability can be limited to repair, replacement or supplying the services again (section 64A), unless reliance on the limit is not fair or reasonable.
A term that purports to exclude, restrict or modify the consumer guarantees is void to that extent (section 64(1)).
Testing, notification and certificates
| Duty | Who | Source |
|---|---|---|
| See that the work, and the examinations and tests of it, are carried out as the regulations require | The licensed gas fitting contractor (or licensed building work contractor) engaged for the work | Gas Act section 56(1), (3)(a); maximum penalty $50,000 for a body corporate, $10,000 otherwise |
| Comply with the regulations' requirements on notification and certificates of compliance | Where a registered gas fitting worker does the work | Section 56(2); maximum penalty $5,000 |
The timing and form of certificates are set by the regulations, which this guide does not restate. The contract should say that the certificate is part of the work, that the client receives a copy, and that final payment is not withheld because of a delay in the client’s own paperwork.
Rectification directions within two years
Section 57 of the Gas Act lets the Technical Regulator direct rectification of an unsafe or non-compliant gas installation, and the direction can be given to the person who did the work within two years before the direction. A gas fitter’s terms should deal with that tail:
- Notice. The client tells the gas fitter promptly of any direction or inspection that concerns the work.
- Access. The client gives access to rectify, at reasonable times.
- Later work by others. Where another trade has altered the installation since handover, the terms say who bears the cost of rectification the direction requires.
- Builder subcontracts. The subcontract allocates the cost where the non-compliance comes from the builder’s design, materials or later work.
- Records. Test results, photographs and the certificate are kept for at least the two-year window.
Getting paid for gas fitting work
- Homeowner jobs under $20,000. Gas fitting at a house is prescribed building work (Building Work Contractors Regulations regulation 4(1)(h)); under $20,000 it is minor domestic building work and Division 1 of Part 5 does not apply (section 27(2)).
- Homeowner jobs of $20,000 or more. A written contract with Form 1, a deposit of no more than 5% and progress payments only for work already performed (sections 28, 30).
- Charging clauses. A domestic gas fitting contract with a charging clause must be in writing and meet section 33B of the PGE Act, including the prescribed notice.
- Builders and commercial clients. On a reading of section 5(1)(b) and (c) of the Security of Payment Act, gas pipework and heating installed in buildings is construction work, so payment claims under the Act are available and pay when paid clauses have no effect (section 12).
- Running accounts. Years of work on invoices without a written contract leave the terms to be proved, as Cassar, below, shows.
What the gas fitter pack holds
A gas fitter pack is built from our masters and a gas fitter schedule, and quoted as a fixed fee before we start.
- Gas fitting terms for homeowners with appliance supply, warranty and certificate clauses.
- A gas subcontract for builders, with a rectification direction clause.
- Commercial terms with section 64A limits for commercial kitchens and plant.
- A handover record for tests, photographs and the certificate.
- A domestic building work contract for gas jobs of $20,000 or more.
How similar matters tend to play out
These are illustrations built from the rules above, not predictions. Every job turns on its own contract and facts.
The direction in month 20. A Technical Regulator inspection finds a non-compliant flue on a heater installed 20 months earlier, and the direction goes to the gas fitter (section 57). The terms required notice, access and records, and the handover photographs show the flue was altered by a later renovator. The terms put the cost of rectifying later alterations on the client.
The appliance retailer’s installers. A retailer sells cooktops “fully installed” and books contract gas fitters. On a reading of section 3, the retailer is performing gas fitting and needs a gas fitting contractor licence.
The cooktop the client bought online. The client supplies a cooktop that turns out to be unsuitable for the gas type. The terms said the gas fitter installs client-supplied appliances as supplied and checks suitability before fitting, so the fitter stopped and quoted the alternative.
Gas fitting case law
| Case | Court | Principle | Pinpoint |
|---|---|---|---|
| Green Engineering (Vic) Pty Ltd v Deputy Commissioner for Consumer Affairs [2016] SASC 162 | Supreme Court | A company that contracted to supply and install, using licensed workers for the regulated work, pleaded guilty to carrying on business as a contractor without a licence; the Court explained why that breached section 6 | [4], [5], [12], [36], [43] |
| Cassar Plumbing Pty Ltd v Virginia Nursery Pty Ltd [2012] SADC 99 | District Court | A plumbing company's claim for gas, fire service and other work done over years without a formal contract was assessed and allowed; the counterclaim failed | [5], [6], [102], [269], [285] |
Case notes
Green Engineering (Vic) Pty Ltd v Deputy Commissioner for Consumer Affairs [2016] SASC 162
A Victorian company sold and installed solar systems in South Australia without a South Australian contractor licence, using licensed electricians for the electrical work ([4], [5]). It pleaded guilty to carrying on business as an electrical contractor without a licence. Doyle J explained that, by contracting to supply and install the systems, it organised or arranged the performance of regulated work ([12]). The definition of perform was then in section 4 of the Act and is now in section 3, in materially the same words on organising or arranging. The appeal against sentence was allowed and the fines reduced to a total of $44,800, of which $17,500 was for the licence offence ([36], [43]).
Cassar Plumbing Pty Ltd v Virginia Nursery Pty Ltd [2012] SADC 99
Over several years from 2004, a small plumbing company put in a natural gas line, fire service pipework and hydrants, sewer, kitchen drains and water lines at a nursery complex ([5]). There was no formal contract and no quotations, and the invoices were partly paid ([6]). The District Court assessed the company’s claim at $55,680.60 ([102]). The owner’s defence that the company was unlicensed was not pursued and was rejected ([269]), and its counterclaim was dismissed ([285]).
How we build gas fitter terms and conditions
We start with the gas work you do, who supplies the appliances and who you work for.
| Stage | What happens | What we do |
|---|---|---|
| 1. Intake | A questionnaire on your licence and registrations, your appliance supply, your clients and your commercial work | We sort your jobs into homeowner, builder and commercial work |
| 2. Review | Your quotes, appliance warranties, handover records and any direction you have received | We mark warranty terms that overreach the guarantees and gaps in your records |
| 3. Drafting | Masters and the gas fitter schedule | We draft your terms, subcontract, commercial terms and handover record |
| 4. Delivery | Word documents and a records checklist | We brief you on certificates, records and the two-year window |
We cannot promise that terms prevent every dispute. Terms that match how gas work is tested, certified and handed over decide most of them before they start.
Before your next gas installation. Book a same-day free 30-minute consultation or call (08) 7094 2021.
Frequently asked questions
Do gas fitters need a separate licence from plumbers in SA?
Yes. Gas fitting is a separate class of contractor licence from plumbing (PGE Act section 7), and each worker needs registration for the gas fitting work done personally (section 13).
Can a plumber do gas fitting work?
Only with gas fitting authority: a contractor licence that covers gas fitting for the business, and registration for gas fitting for the worker (sections 6(1), 7, 13).
Can anyone connect a gas bottle?
Connecting or disconnecting a gas cylinder and portable equipment is exempt work (regulation 4(5)(b)). Other work downstream of the cylinder is gas fitting.
Who must provide a gas certificate of compliance?
Where a registered gas fitting worker does the work, the regulations’ requirements on notification and certificates of compliance must be complied with (Gas Act section 56(2)). The contract should say the client receives a copy.
Can the Technical Regulator make me fix work I did last year?
Yes. A rectification direction can be given to the person who did the work within two years before the direction (Gas Act section 57).
Can a retailer sell gas appliances installed without a gas fitting licence?
On a reading of section 3, no. “Perform” includes organising or arranging the work, so a retailer that contracts to supply and install performs the gas fitting and needs a contractor licence.
Does a gas fitter need a builders licence?
Not for building work the gas fitting licence authorises (Building Work Contractors Regulations regulation 5(1)). Other building work needs one.
What if a gas appliance I supplied is faulty?
Goods supplied to a consumer must be of acceptable quality (Australian Consumer Law section 54), and the manufacturer’s warranty sits beside that guarantee. The terms should say how warranty faults are handled and charged.
Does my licence number need to be on my quotes and ads?
A licensed contractor’s advertisement must state the licence number (section 33A), and a domestic contract with a charging clause must state the business name and licence number (section 33B).
Do I need a lawyer for gas fitter terms and conditions?
The law does not require one, but gas work carries certificates, records and a two-year direction window. We draft gas fitter terms and conditions for South Australian gas fitters that match how the work is tested and handed over.
Related trade contract guides
Related guides
- Plumbing and electrical contracts SA
- Plumber terms and conditions SA
- Hot water installer terms and conditions SA
- Electrician terms and conditions SA
- Drainer terms and conditions SA
- Appliance installer terms and conditions SA
- Kitchen renovator terms and conditions SA
- Minor domestic building work SA
- Domestic building work contracts SA
- Trade contracts SA
- Subcontractor agreements